3
Any Code + Any Code to unlock
1. Enter: # - Master Code - # - 1 - # - 1 - #
2. The lock will indicate a valid setting change
with a single signal.
Master or Manager Code + User Code to
unlock
1. Enter: # - Master Code - # - 2 - # - 2 - #
2. The lock will indicate a valid setting change
with a single signal.
Opening your safe in dual user mode
1. Enter: * - 1st Code - # - 2nd Code - #
2. The lock will indicate a valid code entry with
a single signal and the open light will stay
green for fi ve (5) seconds.
3. Turn the handle clockwise before the green
light disappears
Returning to single user mode
(Single code to unlock)
1. Enter: # - Master Code - # - 0 - # - 0 - #
2. The lock will indicate a valid setting change
with a single signal.
Dual user mode
When you want two people to open the safe; set your safe to dual user mode. One person enters their code and within sixty (60) seconds, the second code is
entered. Always perform this operation with the door open.
4
Activate time delay
1. Enter: # - Master Code - # - (01-99) - # -
(01-99) - #
2. The lock will indicate a valid setting change
with a single signal.
Example: # - Master Code - # - 05 - # - 05 - #,
this will set a fi ve (5) minute time delay.
3. Press * or # to initiate the Time Delay.
When time delay is set
(During the time delay period the keypad will
not respond to any entries)
The lock will fl ash once every fi ve (5) seconds
during time delay and will fl ash once every
second during the last ten (10) seconds of the
time delay ending with a double signal.
The lock will fl ash twice every fi ve (5) seconds
during the open period. The open period length
is two (2) minutes.
During the open period you can open your
safe (see “How to open your safe, Step 1) or
program your safe (following the steps of any
programming procedure).
Deactivate time delay
1. Enter: # - Master Code - # - 00 - # - 00 - #
2. The lock will indicate a valid setting change
with a single signal.
Time delay mode
Always perform this operation with the door open. This function will delay both the opening and programming of the lock.
5
This kit contains:
• Four (4) Masonry Anchors
Required tools:
• Powered Drill
• Adjustable Wrench
• 1/2 in. (M12) Masonry Drill
Instructions:
1. Unlock safe and open door.
2. Remove safe fl oor carpet.
3. Look on the bottom of safe for four (4)
holes with cap plugs.
4. Remove the cap plugs.
5. Position the safe in the desired location.
6. From inside the safe mark the location of
the four (4) bolt down holes.
7. Move the safe aside to the clear marked
spots for drilling.
8. Using the ½ in. masonry drill, drill a 4 in.
deep hole in the marked locations.
9. Replace the safe in the desired location
with the holes in the safe aligned with the
drilled holes in the fl oor.
10. Pass each masonry anchor through the safe
fl oor into the drilled holes; making contact
with the safe fl oor.
11. Tighten each masonry anchor with the
adjustable wrench.
12. Replace safe fl oor carpet.
Floor Mount (optional)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais