Sentrysafe SPD 5.5.5 Manual do Utilizador descarregar pdf (Página 40)

Sample Sequencer

Installation

SENTRY Equipment Corp • P. O. Box 127 • Oconomowoc, WI 53066 • 262/567-7256 • FAX: 262/567-4523

Web: www.sentry-equip.com • e-mail: [email protected]

4. Connect one 22 gauge wire from each valve to a neutral terminal labeled N on terminal block

J1 of the valve relay board. See above warning about using 3/8" cable with Sentry valve.

5. The valve board in the standard Sample Sequencer comes pre-wired to the I/O Board. If using

the optional remote valve output board, then connect the 22 gauge seven conductor cable

(Belden 9430) from the color coded J1 terminals on the Sample Sequencer I/O board to color

coded J2 terminals on the valve relay board. Knockouts for 1/2" conduits are provided in

remote valve board enclosure. The maximum cable length recommended is 32 ft. (10m).

FIGURE 16 - Solenoid Sample Valve Connections

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 81 82

Sem comentários

Sentrysafe SPD 5.5.5 Manual do Utilizador Página 40