SentrySafe QE5541 Manual descarregar pdf (Página 3)

1

Accessing your safe

Opening your safe for the ﬁ rst

time (keep door open during setup):

See lock-out screw and tag instructions on

the inside of the safe door, if equipped.

1. Remove and

discard the

screw at the

base of the

lock case

(ﬁ g. A).

2. Turn the

electronic lock case to the right

(clockwise) (ﬁ g. B), from 12 o’clock

to 2 o’clock, and remove. Insert four

new batteries to power the lock (four

alkaline AA batteries, equaling voltage:

6Vdc, are required and are not included

in this kit). Replace the electronic lock

case and turn to the left (to 12 o’clock)

to reassemble.

3. Turn the key to the right so that the lock

cylinder pops out.

4. Enter the factory code (printed on the

ﬁ rst page of this guide), then press

the Prog/Enter key. When the unlocked

padlock icon(

) appears, you have

four seconds to turn the handle down

to open. Try this several times before

proceeding to the next step.

To lock safe:

Close the door and return the handle to

the horizontal position.

NOTE: This unit is equipped with a water-

resistant gasket. Additional pressure to the

left corner of the door may be required

before the handle can be returned to the

horizontal position.

Battery replacement

The battery icon ( ) will light when the

batteries need to be replaced. No codes

are erased when old batteries are removed

for replacement. See “Opening your safe

for the ﬁ rst time”.

NOTE: If your safe does not appear to be

working, please check batteries before calling

Sentry Customer Care.

B

A

2-E

1 2 3 4 5 6 7 8 ... 32 33

Comentários a estes Manuais

Sem comentários