SentrySafe QE5541 Manual descarregar pdf (Página 8)

Tools needed

for floor mounting:

• Drill

• Wrench

• 7⁄16" (11.0 mm) drill bit

Wood anchoring:

9⁄32" (7.2 mm) drill bit

Masonry anchoring:

3⁄8"(9.50 mm) drill bit

Instructions:

1. Tip the safe onto its right

side. (Door hinges horizontal

with the floor.)

2. Unlock the safe and open

the door.

3. Look on the bottom of the

safe for two indentations

in opposite corners. Using

the 7⁄16" (11.0 mm) bit,

drill a hole through each

indentation perpendicular to

the bottom of the safe.

(Fig. A)

4. Close the door and tip the

safe upright. Place it where

desired and reopen the door.

5. Use a screw or drill bit to

mark the floor through both

holes. (Fig. B)

6. Move the safe aside to

clear both marked spots

for drilling.

7. Drill into the floor:

A. For wood: Using the

wood drill bit, drill a hole

2-1⁄2" (64 mm) deep in

each marked spot. (Fig. C)

B. For masonry: Using the

masonry bit, drill a hole

2-1⁄2" (64 mm) deep in

each marked spot. (Fig. C)

Install a masonry anchor in

each hole.

8. Replace the safe in the

desired position, with the

holes in the safe aligned

with those in the floor.

9. Securing the safe:

A. For wood: Pass each lag

screw through a washer,

then through the safe and

into a hole. Tighten with the

wrench. (Fig. D)

B. For masonry: Pass each

lag screw through a washer,

then through the safe and

into a masonry anchor.

Tighten with the wrench.

(Fig. E)

5

Floor Mount (optional)

A

B

C

D

E

7-E

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 32 33

Comentários a estes Manuais

Sem comentários